HVAC, Electrical & Water Heaters in Battle Creek, MI

Completed installation of 2.5-ton Lennox air conditioning system with matching evaporator coil at rear of residence. Installed new outdoor condensing unit on pad, ran refrigerant lines through exterior wall, mounted electrical disconnect box, and established new dedicated electrical circuit per permit requirements. System tested and operational upon completion.

Conducted on-site evaluation for complete air conditioning system replacement. Assessed existing HVAC infrastructure including ductwork dimensions, furnace clearances, and equipment placement in basement utility area. Documented measurements and spatial requirements for new AC installation scheduled within next month, with existing furnace approximately five years old and in serviceable condition.

Conducted site assessment for new central air conditioning system installation at residential property with no existing AC unit. Evaluated mechanical room and utility space to determine equipment placement and clearance requirements. Measured available space within existing ductwork and utility area to verify proper sizing and fitment for new condensing unit and air handler. Documented measurements of sheet metal ductwork openings and clearances around existing water heater and plumbing infrastructure. Assessed copper line routing paths and electrical wiring locations to plan refrigerant line set installation. Photographed confined space dimensions and equipment positioning to prepare accurate equipment specifications and installation plan. Provided customer with financing information as requested for complete system replacement.

Responded to no cooling complaint on 11-month-old Ruud HVAC system located in basement. Performed diagnostic evaluation of furnace and air conditioning components, inspected ductwork connections, and verified system specifications against manufacturer labels. Unit found to be operating properly after inspection; documented equipment condition with photos showing installation, PVC venting, metallic ductwork, and gas connections all in satisfactory condition.

Responded to emergency water leak call for 1-year-old AC system causing carpet damage in basement area. Upon inspection, diagnosed clogged condensate drain line as source of water overflow. Cleared blockage from PVC drain pipe, verified proper drainage flow, and tested system operation to confirm leak was resolved and condensate was draining correctly.

Completed full HVAC system installation including a 70,000 BTU furnace and 3-ton air conditioning unit with left-side configuration. Installed humidifier integration and ran new dedicated electrical circuit with exterior disconnect box and conduit. All mechanical and electrical permits obtained prior to installation, and system commissioned successfully.

Responded to callback for poor cooling and blank thermostat following recent furnace and air conditioning installation. Upon arrival, inspected newly installed HVAC system including all electrical connections, thermostat wiring, and control circuits. Verified proper power supply to thermostat, checked for loose connections at equipment and wall plate, and confirmed communication between thermostat and new furnace/AC unit. System tested and operational at time of departure.

Completed scheduled air conditioning maintenance service at residential property. Replaced air filter with HCF20-11 MERV 11 filter as needed. Inspected furnace and air handler unit, verified proper operation of condensate pump and drainage system. Documented equipment condition with photos showing Richmond water heater, HVAC system components, and ductwork connections all functioning properly. Service completed within customer's requested timeframe.

Completed full HVAC system installation including new furnace and air conditioning unit. Installed Lennox digital variable-capacity equipment with integrated humidity control, temperature management, wireless connectivity, and diagnostic capabilities. Routed refrigerant lines and connected all ductwork transitions to existing infrastructure. System commissioned and tested for proper operation. Necessary permits were obtained prior to installation. All financing documentation processed and submitted electronically for approval.

Responded to service call for unit not cooling and water leaking. Upon arrival, inspected 20+ year old outdoor condensing unit and indoor air handler system. Found primary drain line completely clogged, causing condensate backup and water leakage. Cleared blockage from drain line and verified proper drainage flow. Checked refrigerant levels, airflow, and electrical connections. System tested and restored to normal cooling operation with no further leaks detected.

Conducted on-site assessment for HVAC system replacement estimate as part of furnace and air conditioner upgrade inquiry. Evaluated existing air conditioning equipment and ductwork configuration in mechanical space, documenting current system installation including air handler unit and associated ductwork connections. Photographed equipment layout and existing infrastructure to support replacement proposal development for complete heating and cooling system upgrade.

Conducted on-site assessment for furnace replacement estimate in residential basement. Evaluated existing 10-year-old vertical furnace system with current ductwork configuration, electrical service panel capacity, and installation requirements for new equipment to facilitate routine replacement with no immediate system failures present.

Completed furnace installation with 70,000 BTU unit, including humidifier integration and reconnection of existing gas lines. Installed 4x25 chimney liner to ensure proper venting and code compliance. All mechanical permits obtained and system tested for safe operation upon completion.

Conducted full system estimate for residential HVAC replacement in basement installation. Evaluated existing 16-year-old furnace and assessed space for addition of central air conditioning system, as current setup lacks cooling capability. Inspected utility area including electrical panel, existing ductwork infrastructure, and available space for new equipment installation. Documented current system configuration and provided comprehensive quote for complete furnace and AC system replacement to meet customer's cooling needs within the current season timeframe.

Performed standard preventative maintenance service on York brand air conditioning system. Conducted visual inspection of outdoor condenser unit, verified operational status, and documented equipment condition through photographs. Unit found to be in functional working order with normal signs of outdoor weathering. No immediate repairs or concerns identified during service call.

Provided estimate for complete HVAC system replacement in basement location, including natural gas furnace and air conditioning unit under promotional offer. Current 30-year-old furnace operational but air conditioning system non-functional. Assessed existing equipment configuration, ductwork connections, and installation requirements for new matched system in basement mechanical room alongside water heater.

Responded to no cooling call with thermostat displaying blinking "cool on" message and indoor blower failing to operate. Upon arrival, verified heat mode functioned properly while cooling mode failed to engage blower motor. Inspected outdoor condensing unit and indoor air handler in attic space. Diagnosed failed blower motor relay or control board issue preventing 24-volt call signal from energizing indoor fan during cooling cycle. Traced electrical connections from thermostat through furnace control board and confirmed lack of power delivery to blower motor during cooling demand. Recommended control board replacement or relay repair to restore cooling function, as outdoor unit ready to operate but indoor air circulation component not responding to thermostat commands.

Responded to no-cool call on 15-year-old central air conditioning system. Upon arrival, inspected outdoor condenser unit positioned against exterior wall with minimal clearance and surrounded by vegetation. Unit showed signs of outdoor exposure with accumulated dirt and debris on exterior surfaces and mesh panels. Performed diagnostic evaluation to determine cause of cooling failure on aging system.

Successfully installed a complete 2-ton air conditioning system with matching evaporator coil on a Goodman furnace unit in the basement mechanical room. The installation included proper refrigerant line connections on the left side of the unit, electrical hookups with conduit and controls mounted to the wall, condensate drainage system with PVC piping and pump, and metallic flex ductwork connected to the furnace plenum. All mechanical and electrical permits were obtained, system was tested and operational, and installation photographs were documented for record purposes.

Responded to service call for no air conditioning in upstairs master bedroom. Performed inspection of attic bedroom space and identified disconnected HVAC supply line preventing conditioned air from reaching the room. Documented existing conditions and room layout for estimate preparation. Provided customer with two comprehensive estimates: first option for reconnecting the upstairs ductwork as part of a complete central air conditioning system installation for the entire home, and second option for installing a ductless mini-split system to serve the affected bedroom independently.