HVAC Repair & Electrical Services in Okemos, MI

Performed comprehensive cooling system tune-up on residential HVAC unit. Inspected and evaluated air filtration system, noting accumulated dust and debris on pleated filters with diamond pattern mesh. Completed standard maintenance procedures including system performance verification, with all components operating within normal parameters and no deficiencies identified.

Completed annual cooling maintenance on Bryant air conditioning system. Replaced air filter, inspected condensing unit exterior condition and evaporator coil which showed significant corrosion and oxidation on copper refrigerant lines indicating age-related deterioration. All components operational at time of service completion.

Responded to non-operational air conditioning system that had been inoperative for approximately one year. Upon diagnostic inspection of 1995 vintage equipment located in basement, identified failed control board as primary cause of system failure. Visual inspection revealed corroded capacitor terminals with white crystalline deposits and rust-colored deterioration on motor component, indicating electrical degradation. Control board displayed multiple wire connections across various terminals with visible wear on PCB components. Documented equipment condition through photographic evidence showing extent of component deterioration and recommended complete control board replacement to restore system functionality.

Completed routine AC tune-up on 1-year-old central air conditioning system with no reported issues. Inspected evaporator coil and found moderate dust and debris accumulation on mesh surface; cleaned coil to restore optimal airflow and heat transfer efficiency. Replaced existing air filter with new FilterBuy MERV-rated filter to maintain proper system operation and indoor air quality.

Responded to service call for water dripping from central air conditioning system approximately 4 feet above floor level. Inspected condensate drainage system and cleared blockage from PVC drain line running along floor to drain outlet. Identified secondary leak source at elevated condensate line near air handler unit. Cleared algae buildup and debris from primary drain pan and secondary overflow port. Verified proper drainage flow through both primary and auxiliary drain lines. System tested and confirmed operational for cooling with no further water leakage observed during service visit.

Completed full package unit installation including mechanical reconnection of all components. Installed new digital programmable thermostat and verified proper system operation with temperature control functionality. All necessary permits were obtained prior to installation, and final system testing confirmed proper airflow and cooling performance.

Completed annual cooling maintenance on residential air conditioning system. Performed comprehensive inspection of outdoor condenser unit, verified proper operation of all components, and documented equipment condition with photographs. Unit found in good working order with no immediate service needs identified.

Responded to no cooling complaint on central air conditioning system. Upon arrival, found outdoor condenser unit with inoperative fan motor producing humming sound, indicating electrical failure or seized motor bearings. Diagnosed failed condenser fan motor on 6-9 year old residential split system AC unit. Replaced defective fan motor with OEM equivalent component, verified proper rotation and airflow. Tested capacitor and contactor operation, confirmed proper amperage draw and system pressures. Unit restored to full cooling operation with normal sound levels.

Responded to no cooling complaint with weak airflow and unresponsive Carrier Infinity thermostat. Diagnosed 10+ year old outdoor condenser unit and thermostat system, identifying communication failure between thermostat and air handler preventing temperature adjustment and proper system operation. Restored cooling functionality and verified thermostat control response.

Completed full HVAC system installation including a 70,000 BTU furnace with humidifier and 3-ton air conditioning unit. Indoor equipment installed on platform base in basement with proper condensate drainage via PVC piping, flexible ductwork connections, and refrigerant line sets between units. Outdoor Lennox condenser unit positioned on pad with electrical and refrigerant connections completed to manufacturer specifications.

Completed full HVAC system installation including a 90,000 BTU furnace with humidifier and 3.5-ton air conditioning unit with rear discharge configuration. All equipment was installed per manufacturer specifications, with PVC venting routed through basement ceiling joists and condensate drainage properly configured. The Lennox condenser was positioned on a protective pad with paver stone base against exterior wall, with all refrigerant lines connected and electrical reconnection completed. Mechanical permit was obtained prior to installation, and all work was performed in compliance with local building codes and industry standards.

Completed installation of 5-ton air conditioning system with matching evaporator coil in left-side configuration. Reconnected electrical service and verified proper operation of condensate pump system in basement location. Programmed and tested Lennox digital thermostat, confirming cooling cycle operation, humidity monitoring, and zone control functionality at 70-degree setpoint.

Completed full installation of 5-ton air conditioning system with matching evaporator coil at residential property. Positioned outdoor condenser unit on deck with proper condensate pan and installed electrical disconnect box with PVC conduit connections. Installed indoor air handler with evaporator coil in basement utility area, suspended horizontally with proper ductwork integration and support strapping. Reconnected all electrical connections, established refrigerant lines between indoor and outdoor units, and verified proper airflow through existing ductwork system. All work performed in accordance with mechanical permit requirements for left-side configuration installation.

Responded to callback regarding condenser coil condition following previous fuse replacement service. Performed visual inspection of outdoor unit and documented coil condition with photographs. Upon examination, condenser coils showed normal weathering and dirt accumulation consistent with outdoor exposure, but no structural damage or compromised fins were observed that would affect system operation or efficiency.

Responded to no-cooling call on 2-year-old Lennox system with frozen indoor unit and continuously running outdoor unit. Upon inspection, discovered severely restricted airflow due to heavily contaminated evaporator coil with significant dust, debris, and microbial growth accumulation, along with dirty air filter. Cleaned evaporator coil, replaced air filter, verified proper airflow restoration, and confirmed system returned to normal cooling operation with outdoor unit cycling appropriately.

Completed annual HVAC maintenance inspection including filter replacement and system accessibility check. Removed heavily soiled pleated air filter showing significant dust accumulation and inspected attic-mounted equipment access point, verifying proper clearance and mechanical component accessibility. All system components inspected and found operational with no immediate service concerns identified.

Provided estimate for replacement of 11-year-old non-functional Magic Pak combination furnace and air conditioning unit located in utility closet. Current equipment exhibited extensive rust damage and was no longer operational. Assessed installation requirements including existing ductwork configuration, gas line connections, and through-wall exterior venting for new system replacement.

Responded to service call for water leaking from air conditioning unit. Upon arrival, performed comprehensive diagnostic inspection of 8+ year old outdoor condensing unit and indoor HVAC system components including furnace, air handler, and associated ductwork. Inspected evaporator coil drain pan and condensate drain line for blockages or overflow conditions. Examined all refrigerant line connections, fittings, and insulation for signs of moisture accumulation. Verified proper operation of condensate pump if applicable and cleared primary and secondary drain lines as needed. Checked air handler cabinet for water stains or active leaks. Assessed system airflow and filter condition to rule out frozen evaporator coil as leak source. Documented equipment conditions with photographic evidence showing basement mechanical room installation with Lennox furnace, air handler cabinet, and connected ductwork systems. No parts or labor warranty applicable to this unit. Completed diagnostic evaluati

Successfully completed installation of 3.5-ton air conditioning system with matching evaporator coil at residential property. Outdoor condensing unit positioned on concrete pad against exterior wall with proper clearances, connected via refrigerant lines and electrical conduit routed through wall penetration. Indoor evaporator coil installed above existing Bryant furnace in basement utility area with PVC condensate drain lines properly configured. System startup performed with refrigerant line connections verified, electrical connections secured, and all components tested for proper operation. Permit requested for mechanical and air conditioning work prior to installation.

Performed estimate for complete AC system replacement on 10-year-old Lennox central air conditioning unit with complete refrigerant loss due to system leak. Evaluated existing air handling unit in basement and outdoor condensing unit installation, documented current system configuration including ductwork connections and drainage lines, and provided replacement options including warranty coverage information for new equipment installation.