HVAC, Water Heater & Electrical Services in East Lansing, MI

Completed annual cooling maintenance on residential HVAC system. Inspected outdoor condenser unit and indoor thermostat, replaced air filter, and verified proper system operation. All equipment found in good working condition with no issues identified.

Completed routine air conditioning maintenance on Lennox outdoor condenser unit. Inspected system components, verified proper airflow through louvers and fan assembly, and checked air filter condition. Unit operating within normal parameters with no issues identified during this scheduled preventive maintenance visit.

Responded to service call for rooftop HVAC system at indoor storage facility reporting improper operation. Inspected Distinctions brand central air conditioning unit and electrical connections at terminal block, verifying all wire terminations and power supply integrity. System was found operational with ability to cool; documented equipment condition with photos for facility records.

Completed on-site evaluation for replacement of existing gas tank water heater. Assessed current working unit and existing plumbing infrastructure, including wall-mounted equipment with complex PEX and copper supply line configurations, shut-off valves, and pressure relief components. Documented installation specifications for gas-fired water heater replacement, noting natural draft venting requirements and existing mechanical room layout with color-coded hot and cold water distribution systems.

Completed comprehensive tune-up maintenance on residential furnace and central air conditioning system per 10-year category service protocol. Performed full system inspection with access panel removal, checked all internal components including electrical connections, circuit boards, valves, and wiring harness for proper operation and wear. Verified venting system integrity, inspected PVC condensate drainage lines and fittings, and confirmed proper airflow through ductwork. System tested and found operating within normal parameters with no deficiencies noted.

Provided estimate for air conditioning system replacement at residential property. Current 5-year-old outdoor condenser unit, located on concrete pad in side yard between buildings, is non-operational and requires full replacement. Indoor air handling equipment is positioned in basement and will be included in replacement scope.

Completed spring maintenance on residential HVAC system including furnace inspection and air conditioning tune-up. Performed comprehensive AC diagnostics using manifold gauge set to measure refrigerant pressures and verify system operation on outdoor condensing unit. All equipment found operating within normal parameters with no issues identified during inspection.

Responded to service call for air conditioning system startup at commercial property. Upon arrival, located basement AC unit and exterior disconnect box. Inspected electrical disconnect, confirmed fuses were intact and properly seated in holders. Closed and secured disconnect box. Energized system at thermostat, verified compressor and condenser operation. System cooling properly with no issues detected.

Responded to service call for central air conditioning system experiencing reduced cooling capacity and intermittent cycling mechanism. Upon inspection, found refrigerant lines and electrical connections at exterior unit showing signs of potential issues affecting system performance. Diagnosed short cycling of compressor while blower motor continued operation, indicating cooling system not reaching optimal temperature despite adequate airflow. Inspected refrigerant line set, electrical connections, and control components to identify cause of reduced cooling efficiency and abnormal cycling pattern.

Completed comprehensive annual maintenance on 15-year-old residential air conditioning system. Performed full system inspection including electrical connections, refrigerant pressures, condenser coil cleaning, and operational testing. Unit operating within normal parameters with no deficiencies noted. All components functioning properly at time of service completion.

Responded to callback for water leak following humidifier installation. Upon inspection, confirmed that drain cap was cross-threaded causing the leak. Removed and properly reinstalled cap with correct threading, verified no active leaks, and inspected surrounding area for water damage.

Provided comprehensive estimate for replacement of 50-year-old natural gas furnace and air conditioning system currently located in basement. Both units are operational but have reached end of serviceable life expectancy. Assessed existing installation configuration, ductwork connections, electrical service capacity at exterior meter, and clearance requirements for new equipment installation in basement location.

Conducted on-site evaluation for cooling system replacement of approximately 20-year-old Bryant air conditioning unit. Documented existing HVAC infrastructure including ductwork configuration, mounting hardware, and clearance measurements in mechanical room. Provided replacement system estimate for installation scheduled in upcoming year.

Performed comprehensive AC tune-up and maintenance on a 2-year-old central air conditioning system. Conducted system diagnostics using manifold gauge set to verify refrigerant pressures and operating parameters on R-410A system, confirmed proper refrigerant charge levels and system performance. Inspected outdoor condenser unit including fan assembly, coil condition, and electrical connections; all components found operating within manufacturer specifications with no deficiencies noted.

Responded to service call for condensate pump running continuously with no water discharge. Upon inspection, found the blue condensate pump at base of air handler was cycling but not pumping water through drain line to sink. Diagnosed blockage in discharge tubing and cleared obstruction, restoring proper condensate drainage. Verified pump operation and confirmed system returned to normal function with condensate flowing correctly through drain line.

Responded to no cooling call and performed diagnostic inspection of outdoor condensing unit. Upon arrival, conducted visual assessment and operational testing of the air conditioning system. Inspected condenser unit exterior, coil condition, and associated refrigerant lines and condensate drainage system. Unit showed normal outdoor weathering consistent with age but no visible signs of significant damage or corrosion to cabinet or coil surfaces. Completed troubleshooting procedures to identify root cause of system failure and determine appropriate repair recommendations.

Completed installation of 150-amp electrical service panel upgrade. Coordinated utility disconnect and reconnect with power company for safe panel replacement. Installed new circuit breaker panel with proper circuit identification labeling for all branch circuits including dryer, range, and air conditioning loads. All work performed to code specifications and passed municipal electrical inspection upon completion.

Returned to complete diagnostic after allowing system to thaw from previous visit. System was experiencing temperature control issues with thermostat stuck at 75 degrees and unable to adjust. Performed comprehensive system measurements using digital manifold gauge set, recording superheat, subcooling, and pressure readings on both high and low sides of the refrigerant circuit. Replaced air filter and evaporator pad as part of maintenance protocol during diagnostic process.

Completed ComfortGuard annual maintenance package on a four-year-old air conditioning system. Performed comprehensive AC tune-up including inspection of outdoor condenser unit, verified proper airflow through louvers, checked fan operation, and documented system condition with photos. System operating within normal parameters with no issues identified; condenser coil showed minor dirt accumulation consistent with normal seasonal use.

Completed comprehensive 5-year ComfortGuard maintenance on Lennox forced-air heating system. Performed full system inspection including furnace, ductwork, air filter housing, and digital thermostat operation. Investigated reported intermittent buzzing noise occurring during fan operation; inspected blower motor assembly, mounting hardware, and ductwork connections for loose components or vibration sources. Verified all PVC exhaust and intake vents properly secured, checked refrigerant line connections, and confirmed proper airflow through mesh filter housing. Tested thermostat functionality and system cycling; unit operating within normal parameters at time of service.