HVAC, Water Heater & Electrical Services in East Lansing, MI

Completed annual cooling maintenance on residential air conditioning unit. Performed comprehensive system inspection, replaced air filter and evaporator pad as needed. Unit operating within normal parameters upon completion of scheduled maintenance visit.

Completed spring AC tune-up on 16-year-old residential air conditioning system. Performed comprehensive maintenance including inspection of outdoor condensing unit, verification of electrical connections at disconnect and meter, assessment of refrigerant lines and PVC condensate drainage, and confirmation of proper fan operation. System operating within normal parameters at time of service; noted moderate rust and corrosion present on condenser top panel consistent with unit age and outdoor exposure.

Completed annual cooling maintenance on Bryant outdoor condensing unit. Performed comprehensive system inspection, checked refrigerant levels, cleaned condenser coils, verified electrical connections, tested capacitor and contactor operation, and confirmed proper fan motor function. Unit operating within manufacturer specifications with no deficiencies noted.

Completed estimate for replacement of 30-year-old Amana furnace system located in basement utility area. Inspected existing heating equipment, ductwork configuration, and associated components including PVC condensate drain lines and electrical connections. Documented current system specifications and installation layout to provide comprehensive replacement options for aging HVAC equipment that has reached end of expected service life.

Completed annual cooling maintenance inspection on residential HVAC system. Inspected basement mechanical room equipment including air handler and ductwork for proper operation and physical condition. Evaluated and documented existing air filter showing moderate dust accumulation with discoloration throughout pleated media, indicating normal service cycle usage. All accessible components including ductwork, connections, and mechanical equipment were visually inspected and found to be in satisfactory operating condition.

Conducted comprehensive site evaluation for air conditioning system replacement at residential property. Assessed existing outdoor AC unit currently in operational condition, documented electrical infrastructure including sub-panel with Cutler-Hammer load center, and inspected basement mechanical room housing Bryant furnace, air handler, ductwork, and associated PVC venting systems. Provided replacement estimate options based on current system configuration and electrical capacity.

Responded to service call for Lennox S40 Smart Thermostat experiencing intermittent disconnection from smart hub system. Diagnosed communication failure between thermostat and furnace control board requiring constant manual resets at equipment. Replaced faulty thermostat unit with new Lennox S40 (catalog number 22V24, part number 107088-01), verified proper wireless connectivity to smart hub, and confirmed stable system operation without further disconnection issues.

Completed comprehensive AC tune-up on new system with no reported issues. Performed standard maintenance including air filter replacement with new pleated media filter, verified proper system operation, and tested electrical voltage readings which measured 24.53 volts, confirming correct low-voltage control circuit operation.

Completed annual heating maintenance tune-up on furnace with no reported issues. Performed comprehensive system diagnostics using digital multimeter to verify electrical readings and system performance. All measurements within normal operating parameters, unit operating properly.

Responded to no hot water complaint at 55-year-old residential property. Upon inspection, diagnosed failed tanked water heater with suspected sediment accumulation affecting heating element performance. Assessed existing gas-fired water heater installation in basement utility area, including exhaust flue system with multiple elbows, copper supply lines with isolation valves (red and white handled ball valves), and associated piping infrastructure. Verified complete loss of hot water throughout home. Documented existing equipment condition and plumbing configuration via photographs showing flexible ductwork in attic/crawlspace area and basement mechanical room with water heater, flue pipe, and shut-off valve assembly. Provided assessment and recommendations for water heater repair or replacement options to restore hot water service.

Completed comprehensive annual maintenance on 26-year-old residential air conditioning system. Performed full system inspection including refrigerant levels, electrical connections, condenser coil cleaning, and operational testing of all components. Unit is functioning properly with no deficiencies noted; system demonstrates good performance despite age, with exterior condensing unit well-maintained and properly positioned on concrete pad with adequate clearance for airflow and service access.

Completed annual cooling maintenance on residential HVAC system. Inspected furnace cabinet, verified air filter condition and proper installation, and examined Aprilaire humidifier attachment and associated components. Documented equipment model information and confirmed all accessible system components, including condensate drain lines and electrical connections, were functioning properly with no immediate service needs identified.

Responded to no heat call on 30-year-old furnace that was unresponsive to thermostat commands with no error codes displayed. Upon inspection, accessed furnace control panel and diagnosed failed control board preventing unit from receiving thermostat signals. Replaced defective integrated furnace control module, verified proper wiring connections, and tested system operation through multiple heating cycles to confirm thermostat communication and ignition sequence were fully restored.

Completed annual cooling maintenance on HVAC system. Performed comprehensive system diagnostics using digital multimeter, recording voltage readings of 627V at indoor unit and amperage draw of 0.53A at outdoor condenser unit. All electrical measurements fall within manufacturer specifications, indicating proper system operation and component functionality.

Completed annual cooling maintenance on residential HVAC system located in basement utility area. Performed comprehensive inspection of air handler unit with multi-panel filter assembly, verified proper airflow through slatted filter banks, and assessed ductwork distribution network throughout the space. Inspected all mechanical connections, copper refrigerant lines, electrical components, and confirmed system operational readiness for upcoming cooling season.

Completed annual cooling maintenance on Bryant residential air conditioning system. Performed comprehensive inspection of outdoor condenser unit, verified proper operation of top-mounted fan and protective grille, checked condenser coil fins for damage and airflow obstruction, and confirmed unit was level on concrete pad. Inspected refrigerant lines, drainage system including corrugated hose, and electrical connections. System operating within normal parameters with no immediate concerns identified.

Completed annual cooling maintenance on HVAC system. Inspected evaporator coil and condenser units, noting significant debris accumulation and soiling on outdoor condenser coils requiring attention. Replaced air filter and documented equipment condition with photographs for maintenance records.

Completed annual cooling maintenance inspection on residential HVAC system. Performed comprehensive system evaluation including inspection of ductwork, plenum assembly, and Bradford White equipment components. Customer enrolled in air care membership program for ongoing preventive maintenance coverage.

Completed annual cooling maintenance on HVAC system. Inspected evaporator coil unit and verified proper operation, replaced 18x25x1 pleated air filter with new AAF Flanders PREpleat filter, and checked condensate drain line for proper flow and function.

Completed full HVAC system installation in residential basement mechanical room. Installed 90,000 BTU high-efficiency Lennox furnace with humidifier and 2.5-ton air conditioning unit with rear discharge configuration. Connected all ductwork with properly insulated supply and return plenums, routed refrigerant lines, established gas supply connections, and completed electrical wiring to all components. Reconnected existing ductwork to new equipment, ensuring proper airflow distribution throughout home. Verified all mechanical permits were obtained prior to installation. System tested and operational upon completion with all safety controls functioning as designed.