HVAC, Electrical & Water Heaters in DeWitt, MI

Responded to no cooling complaint on 6-year-old residential AC system affecting entire home. Upon arrival, performed visual inspection of outdoor condenser unit, which appeared in good physical condition with minor dirt accumulation on cabinet and coils. Documented equipment condition and installation site with photos for service records.

Responded to no-cooling call on 7-month-old Guardian HVAC system located in basement. Upon arrival, confirmed unit was not powering on. Performed diagnostic troubleshooting including verification of thermostat settings, circuit breaker status, and low-voltage control circuit. Identified faulty control board preventing system startup. Replaced defective control board under parts warranty, restored power to unit, and verified proper system operation through complete cooling cycle. Unit now functioning normally with all safety controls operational.

Conducted on-site evaluation for complete air conditioning system replacement. Existing outdoor condensing unit is approximately 37 years old and has reached end of serviceable life. Inspected electrical panel to verify existing circuit breaker configuration and amperage ratings for AC system, documented current 30-amp breaker setup. Measured existing air handler dimensions and clearances to determine equipment specifications for replacement unit. Assessed PVC condensate drain line routing and condition. Photographed electrical panel labeling and existing equipment measurements for accurate replacement sizing and installation planning. Provided estimate for complete system replacement with installation timeline of 2-3 weeks per owner's request.

Returned to property to complete diagnostics on 9-month-old basement HVAC system experiencing zoning failures, inadequate cooling, and elevated energy consumption. Upon arrival, verified evaporator coil had fully thawed since previous visit. Utilized Fieldpiece SMAN refrigerant analyzer to perform comprehensive system diagnostics, measuring refrigerant pressures, temperatures, and superheat/subcool values at outdoor condensing unit. Readings indicated system operating parameters to determine root cause of performance issues and guide necessary repairs under existing parts and labor warranty coverage.

Responded to no-cooling service call for central air conditioning system less than 5 years old with unit not turning on and no fan operation. Upon arrival, discovered water leak issue affecting HVAC equipment and surrounding area, with visible moisture damage and staining on floor and wall surfaces in mechanical room. Inspected condensate drainage system including PVC piping and condensate pump assembly. Addressed water intrusion problem and restored proper system operation, ensuring condensate management components functioning correctly to prevent future leaks.

Provided estimate for complete HVAC system replacement in basement location, including both furnace and air conditioning units. Existing 20-year-old equipment showing signs of age with current unit operating marginally. Assessed existing installation including vertical furnace configuration, ductwork system, condensate drainage assembly with PVC piping, and exterior condenser location with utility connections on vinyl-sided exterior wall.

Completed scheduled Air Care Cooling maintenance on residential split system. Performed comprehensive ACM inspection of outdoor condensing unit, noting moderate accumulation of dirt, debris, and organic material on exterior panels and coil surfaces. Cleaned condenser coil and exterior surfaces to restore proper airflow and heat transfer efficiency. Verified electrical connections at disconnect box, inspected refrigerant lines and drainage components. Unit operational and running within normal parameters upon completion of maintenance protocol.

Responded to service call for 9-month-old system experiencing zone control failure, inadequate cooling, and significant increase in energy consumption. Upon inspection, discovered substantial water damage on basement floor near HVAC equipment, indicating condensate drain line failure or overflow condition. Cleared blocked condensate drain, verified proper drainage function, and tested zone damper actuators for proper operation. Restored system to normal cooling capacity and confirmed all zones responding correctly to thermostat calls.

Completed full HVAC system installation including a 70,000 BTU gas furnace and 2.5 ton air conditioning unit. Installed furnace in basement mechanical room with proper venting using white PVC piping, connected all ductwork, electrical controls, and gas lines. Positioned outdoor condenser unit on gravel pad with refrigerant lines properly secured to exterior wall, evacuated and charged system to manufacturer specifications, and verified all connections and operational parameters meet code requirements.

Completed routine preventative maintenance on Bryant residential air conditioning system. Performed comprehensive inspection of outdoor condenser unit, verified proper airflow through louvered panels and top grille assembly, checked electrical connections and refrigerant lines, and documented equipment condition with photos. Unit operating within normal parameters with adequate clearance from surrounding vegetation maintained for optimal performance.

Conducted comprehensive evaluation of residential air conditioning system experiencing complete cooling failure affecting entire home. Compressor failure was confirmed after relay replacement attempt proved unsuccessful in resolving the issue. Performed detailed measurements and photographic documentation of aged HVAC equipment showing significant wear, heavy dust accumulation, and deteriorated components including heat exchanger with substantial debris buildup. Provided complete system replacement estimate due to advanced age of equipment and extent of component failure making repair economically unfeasible.

Completed annual maintenance package on residential HVAC system including furnace heating tune-up and air conditioning unit inspection. Replaced heavily soiled air filters in both the main system and furnace humidifier assembly, which showed significant dust and debris accumulation. Performed comprehensive system diagnostics, verified proper operation of all components, and ensured optimal airflow throughout the system.

Provided comprehensive equipment replacement estimate for non-operational air conditioning system serving 2,000 square foot two-story residence with natural gas furnace. Existing AC unit located at side of house has exceeded 10+ years of service life and requires full replacement. Assessed electrical panel configuration and breaker capacity to ensure compatibility with new equipment specifications, documented existing Square D breaker panel with properly labeled circuits including dedicated AC disconnect.

Conducted on-site evaluation for Level 2 electric vehicle charging station installation at a residential single-family home. Inspected existing electrical panel to assess capacity and available breaker positions for dedicated 240V circuit required for EV charger. Documented panel configuration showing adequate space for new circuit installation, with digital monitoring device present at main breaker position. Provided estimate for installation of Level 2 charging equipment in garage, including necessary electrical materials, conduit, wiring, and GFCI-protected dedicated circuit per NEC requirements.

Completed installation of 2.5-ton Lennox air conditioning condenser unit and evaporator coil system at residential property. Outdoor condenser positioned on rubber isolation pad in rear yard location with proper clearance from fence and structure, electrical disconnect installed on exterior wall, and refrigerant lines connected. Indoor evaporator coil installed in basement area with existing furnace system, all ductwork connections completed, and system tested for proper operation and refrigerant charge.

Responded to emergency service call for complete HVAC system failure with thermostat displaying critical alert code 124. Upon arrival, diagnosed malfunctioning 5-year-old Lennox S40 Smart Thermostat in basement that had experienced a system update failure, preventing communication with the furnace. Replaced defective thermostat with new Lennox S40 Smart Thermostat (catalog #22V24, part #107088-01, serial #BT25811868). Installed new unit, established proper wiring connections to furnace, configured system settings, and verified successful communication between thermostat and heating equipment. Tested all HVAC system functions to confirm full operational status restored.

Completed comprehensive 5-year ComfortGuard maintenance visit on residential HVAC system. Performed thorough inspection of furnace unit and air handler assembly, including examination of evaporative humidifier pad which showed minor mineral deposits and dust accumulation consistent with normal operation. Verified proper operation of all system components, inspected refrigerant lines and insulation for integrity, checked condensate drainage system and PVC lines for proper flow, and confirmed exhaust venting connections. All equipment found to be functioning within manufacturer specifications with no immediate service needs identified.

Completed full HVAC system installation including a Lennox 90,000 BTU furnace (Model CK40CT-36C-71) and 3-ton air conditioning unit with left-side configuration in basement mechanical room. All ductwork connections completed, system tested and operational. Permits obtained for mechanical installation prior to work commencement.

Responded to no cooling call for four-year-old residential air conditioning system affecting entire home. Performed diagnostic evaluation of outdoor condenser unit and system components. Documented unit condition with photos showing condenser positioned on concrete pad with proper clearance from structure, though vegetation encroachment noted around perimeter requiring attention for optimal airflow and efficiency.

Completed comprehensive full system estimate for replacement of 16-year-old electric furnace and air conditioning system with dual-fuel propane capability. Performed thorough inspection and documentation of existing air handler unit located in basement utility space, evaluating current ductwork configuration, PVC condensate drainage lines, electrical connections, and copper refrigerant piping. Assessed condition of aging equipment showing visible wear, dust accumulation, and surface deterioration on metal cabinet housing. Photographed existing installation including air handler, associated ductwork, plumbing connections, and mechanical room layout to provide accurate equipment specifications and replacement recommendations for complete HVAC system upgrade.